Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
32. Connecting the Fireplace Wiring
• Connect control panel cable to heater.
• Insert the Ember Bed Connection Wire into the
heater.
• Route the Ember Bed Connection Wire down the
side surround rail and along the back of the log
set, securing it in place with the clips as shown.
33. Placing the Fireplace Background
• Locate the Electric Fireplace Back Panel (U).
• Only slightly bend the wallpaper and fit it into the
back of the fireplace.
• Note that this back panel is reversible and can be
placed with either side facing the fireplace insert
for a customizable look.
34. Securing the Fireplace Background
• Place the Back Panel Brackets (NN) between the
Wallpaper and the grooves of the assembly as
shown.
• Fasten each Back Panel Bracket (NN) using
Screws (MM). Repeat until all brackets are in
place as indicated by the diagram.
Hardware Used
Ø3x16mm
MM
Screw
Back Panel
NN
Bracket
23MMP723REV1.0
x 4
x 4
20
32
control panel
cable
Ember Bed
Connection Wire
33
34
U
Publicidad
