Craftsman 172.74536 Manual De Instrucciones página 10

KNOWYOURTRIMMER/EDGER (Fig. 2)
Your trimmer/edger has a precision built
electric motor and it should only be
connected to a 120-volt, 60 HzAC ONLY
power supply (normal household current).
The trimmer should always be used with a
GFCI (Ground Fault Circuit Interrupter) outlet.
DO NOT operate this trimmer on
direct current (DC). The large voltage
drop would cause a loss of power and
the motor would overheat.
If the trimmer does not operate when
plugged into correct 120-volt.60 Hz AC-
ONLY outlet, check the power supply.
The trimmer comes with a 12-in. pigtail
power cord and should be plugged
into a proper extension cord,
Motor
Housing
Handle Rotation
Button
Auxiliary X
Handle
Trigger
Switch
Handle
Cord
Retention
Hook
Pigtail
Power
Cord
AUXllla
Handler_nob
Height Adjustment
Fig. 2
rrlmmer Head
PIGTAIL POWER CORD (Fig. 3)
Your edger trimmer has a 12-inch pigtail power cord. This cord must be attached
to a proper extension cord (see page 7).
Remove the plug guard from the pigtail power cord (see Fig. 3). Make a loop in
the extension cord. Push loop through hole in the handle (see Fig. 3a). Fasten
loop around cord retention hook. Plug trimmer's power cord into extension cord
plug (see Fig. 3b).
Fig. 3
Fig. 3b
10