Publicidad
Idiomas disponibles
Idiomas disponibles
-
The vibration emission level given in this information sheet has been measured in
accordance with a standardized test given in EN 60745 and may be used to compare one
tool with another.
-
The given vibration emission level may be used for the initial estimation of the real exposure.
-
The vibration emission level will vary because of the ways in which a power tool can be used
and may increase above the level given in this information sheet.
-
Try to keep the exposure as low as possible. To reduce the vibration emission level the user
should wear working-gloves and use the machine for limited time.
-
All parts of working cycles have to be considered ( including the time the power tool is
switched off, and the time, when the power tool is running under no-load condition).
Operation
Attaching and changing the sanding paper
•
Always unplug from the mains before changing the sanding paper!
•
Open the clamping device and remove the used sanding paper.
•
Place a new sanding sheet on the sanding disc and make sure that the vent holes in the
sanding paper coincide with those in the sanding disc.
•
Securely clamp the sanding paper on both sides of the sanding disc with the clamping
device.
Switching your finishing sander on and off
The finishing sander is turned on by pulling up the switch (3).
The operating switch can be locked in place by pressing on the locking button (4) at the same
time.
The locking mechanism is released and the finishing sander is turned off by pressing the
operating switch (3) again and letting it go.
•
Turn the machine on first, and then put it on the work piece.
•
Do not use excess pressure, or you risk increased wear on the attachment and the motor.
•
Move the finishing sander over the work piece with low and steady pressure, in circles or
alternating between the longitudinal and the crosswise directions.
•
To prevent sanding through the surface, do not tilt the finishing sander.
•
Do not turn the machine off while is it on the work piece. Lift the machine from the work
piece first, and then turn it off.
•
Never use the finishing sander without sanding paper.
•
To ensure sufficient cooling of the motor, do not cover the ventilation slot with your hand.
Vacuum connection
The finishing sander is provided with an adaptor for a vacuum attachment.
Place the adapter in the intended opening (8) of the machine housing up to the catch and
connect a vacuum.
GB - 15
Publicidad
