Joie i-Snug 2 Manual De Instrucciones página 5

Installation with base
see images -
3 15
1. Unfold the load leg from storage
compartment. 3
2. Fit the ISOFIX guides with the
ISOFIX anchor points.
4
The ISOFIX guides can protect the
surface of the vehicle seat from
being torn. They can also guide the
ISOFIX connectors.
3. If base used previously with
i-Venture seat remove rebound bar
as shown in illustration 5
!
Store safely for future use with
i-Venture seat.
6
5
3
4
5
2
1
1
6
4. Press the ISOFIX release button on
either side of the base, then pull
out the ISOFIX connectors.
5. Line up the ISOFIX connectors with
the ISOFIX guides, and then click
both ISOFIX connectors into the
ISOFIX anchor points.
8
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
6. There are 9 adjustable positions for
ISOFIX. Press the ISOFIX release
button and push the base back
against the vehicle seat until tight.
7. After placing the base on the
vehicle seat, extend the load leg to
floor 9 , When the load leg
indicator shows green means it is
installed correctly, red means it is
installed incorrectly. -1
9
!
The load leg has 24 positions.
When the load leg indicator
shows red this means the load
leg is in the wrong position.
!
Make sure the load leg is in full
contact with the vehicle floor
pan.
!
Squeeze the load leg releasing
button, then shorten the load leg
upwards.
7
7
2
8
1
9
1
1
6