Aeroplane Lnstallation; Handle Adjustment; Installation With Base - Joie i-Gemm Manual De Instrucciones

Aeroplane lnstallation

see images
3
!
The i-Gemm can only be installed
using a lap belt if being used in an
aircraft without the base. Do not
install in a vehicle using a lap belt.
!
When being used in an aircraft, the
infant carrier module must only be
installed rear facing on the seat.
!
i-
Gemm infant carrier module width
is 435mm, but some aircraft seat
widths are 430mm. For narrow
seat, please place padding under
the seat to raise the height and
allow it to fit between the arm
rests.

Handle Adjustment

see images -
4 5
The handle of the infant carrier
module can be adjusted to 3
positions.
4
Position 1 Position for car, hand or
stroller transportation.
Position 2 Rocking position.
Position 3 Baby chair position.
7
3
3
4
1
2
3
To adjust the handle, squeeze the
handle buttons on both sides to
release it 5 -1, and then rotate the
handle until it clicks into any of the 3
positions. -2
5

Installation with base

see images -
6 17
When used with the i-Gemm do not
fit the rebound bar, store safely for
use later with the iAnchor Advance
seat.
1. Unfold the load leg from storage
compartment.
6
2. Fit the ISOFIX guides with the
ISOFIX anchor points.
7
The ISOFIX guides can protect the
surface of the vehicle seat from
being torn. They can also guide the
ISOFIX connectors.
5
2
1
6
7
8