Heraeus Signum HiLite pre Instrucciones De Uso página 19

GB
Safety regulations for polymerisation
• Each time before using, always check to make sure that the device is working per-
fectly and that the accessories are operable. In the event of faults the device must
not be used. Contact Customer Service if the device is affected by faults.
• Never point the light beam at anyone's eyes. Only point the light beam directly at
the polymerisation material
• Before each curing cycle check to make sure that the glare shield is fi tted to the
top of the handpiece.
• When folding together, make sure you do not trap or squash your fi ngers.
Avoid any direct contact between the Signum HiLite pre and the material to be poly-
merised. Polymerised composite residues on the light exit surface (1) impair light
emission and have a negative effect on subsequent cycles.
8. Cleaning
Clean the unit with a moist cloth, making sure that no water gets into the housing of
the device. Do not use aggressive detergents (abrasive powder, solvent).
Safety regulations for cleaning
• The exterior of the charging unit (7) and the handpiece is not protected against
the penetration of liquids! Avoid all contact between liquids and the surface and
the electrical contacts!
9. Device disposal
waste electrical and electronic equipment and, in addition, at the re-use, recycling
and other forms of utilisation of such wastes in order to reduce the quantity of waste
to be disposed of and to reduce the emission of pollutants emerging from electrical
and electronic equipment and wastes.
For disposal of used equipment of the type Signum HiLite pre please call our Service
Hotline, tel. 0 800-43 72 52 2 or contact your local fi eld sales representative.
In other countries please contact your appropriate Heraeus Kulzer GmbH subsidiary or
your local dealer. The device must not be disposed of at local-authority waste disposal
points.
Important !!
Note !!
Important !!
German Electrical and Electronic Equipment Act ('ElektroG')
This law defi nes requirements for product responsibility in accordance with
§ 22 of the German Closed Substance Cycle and Waste Management Act for
Electrical and Electronic Equipment. It chiefl y aims at the avoidance of
8