TRAPP TR-600 Manual De Instrucciones página 81

www.trapp.com.br
When at maximum opening, plastic safety
protections and shafts must be superimposed
at least 1/3 of their length (LT). When at
maximum closing, the minimum gap allowed
is 1 to 2 cm (Figure 1).
Keep terminals aligned.
Fig. 1
Check TDP minimum and maximum length
 
required to couple the machine/ tractor.
In the event of problems, get in touch with
TRAPP nearest Technical Assistant. After
installing, secure cardan safety protections,
both on the tractor and on the machine, with
the chain that comes with the cardan.
Make sure pivots are free. If TDP shaft is
 
equipped with other safety devices, such
as torque limit or a clutch, install them
accordingly.
These operations must be made on adequate
floor only. Stop tractor, disconnect from TDP
and use parking brakes. If necessary, lift the
machine from the ground. For safety reasons,
place it on a support to prevent accidents.
81