Air Filter; Useful Suggestions - TRAPP TR-600 Manual De Instrucciones

Air filter

Motor will not run properly with dirty air filter.
Frequently clean the filter, preferably with
compressed air. See motor manual.
Some problems may occur during the use of the shredder. Find some suggestions to solve them below:
Problem
Shredder
jamming
Low production
Irregular cut
90

Useful Suggestions

Probable cause
Excessive intake/feeding. Organic
material accumulates inside the
machine.
1. Insufficient feeding.
2. Machine revolution below
specification.
3. Humid product.
1. Cutting blades need
sharpening.
2. Worn counter cutting blade.
ATTENTION!
TRAPP ORIGINAL
TRAPP does not undertake
responsibility for eventual
damages caused to the
equipment, neither for
accidents that may occur
due to the use of non-
original parts.
To clean air pre-filter
The pre-filter must be free from dirt to avoid
damage to the motor due to overheating.
Clean with compressed air or wash in
running water with mild soap.
Solution
Turn shredder off. Remove upper output device,
open cover, remove excess of material from inside
the machine. Close cover, replace output device,
turn shredder on, wait for motor to reach maximum
revolution and get back to work. Control machine
intake/feeding.
1. Maintain continuous feeding, yet not
overfeeding which may cause shredder to
jam.
2. Check whether TDP rpm is below 540 rpm.
3. Shred dry material only; humid products may
block output device.
1. Sharpen cutting blades as indicated in
"Sharpen and Replace Blades".
2. Do as item "Check Blades".
Use
!
PARTS.
www.trapp.com.br