Horizon Fitness 7.4 AT Manual Del Propietário página 10

ASSEMBLY STEP 1
PART TYPE
A UPRIGHT GUIDE BOLT
B MAST BOLT
C FLAT WASHER
D SPRING WASHER
4
1
A
C
D
B
10
HARDWARE FOR STEP 1
DESCRIPTION
M8X1.25PX11L
M8X1.25PX80L
8.4X15.5X1.6T
8.2X15.4X2.0T
4
2
C
A
3
A Cut the yellow banding straps and lift the running
deck upward from the rear to remove all contents from
QTY
underneath the running deck.
2
B Open HARDWARE FOR STEP 1.
8
Insert UPRIGHT GUIDE BOLT (A) into MAIN FRAME
C
8
BRACKET (1) and fully tighten.
8
NOTE: Do not fully tighten the following bolts until the
end of STEP 4.
Pull the CONSOLE CABLE (2) away from the treadmill
D
base frame. Connect the CONSOLE CABLE (2) from
the MAIN FRAME (3) to the CONSOLE CABLE (2)
in the bottom of the RIGHT CONSOLE MAST (4).
The other end of the CONSOLE CABLE (2) should be
located at the top of the mast.
E Attach RIGHT CONSOLE MAST (4) to MAIN
FRAME (3) using 4 BOLTS (B), 4 FLAT WASHERS (C)
B
AND 4 SPRING WASHERS (D). Feed the extra console
D
cable back into the upright mast.
NOTE: Be careful not to pinch the console cable
while attaching the right console mast.
F Repeat STEP E on the LEFT SIDE.
A
B
C
D