Publicidad
Idiomas disponibles
Idiomas disponibles
MOVING INSTRUCTIONS
Photo 1
PLEASE READ THESE ASSEMBLY GUIDELINES BEFORE STARTING TO ASSEMBLE THE TRAMPOLINE.
INCORRECT ASSEMBLY WILL CAUSE DAMAGE TO THE TRAMPOLINE FRAME.
Make sure the trampoline is placed on level ground. Uneven ground surfaces may cause the trampoline frame
to warp (Photo 1).
Make sure that all bolts holding the frame joints are tightened completely before installing the springs. Failure
to do this properly will cause the frame to warp.
Make sure NOT to use one's leg to push against the trampoline leg or frame when loading the springs. It will
cause the trampoline to warp (Photo 2).
DO NOT load the springs onto the frame on only one side of the trampoline. Uneven distribution of tension
from the springs will cause the frame to warp (Photo 2).
If the trampoline frame warps up, do not be alarmed as the "Quad-lock" system is designed to be flexible. Push
down on the part of the frame that warped with two people as shown. The frame will level out (Photo 3).
Moving trampoline. If the trampoline and enclosure needs to be moved, it should be moved by two persons at
least, kept horizontal, and lifted slightly. If necessary, the trampoline and enclosure can be taken for moving. To
take the trampoline apart, follow the assembly steps in reverse order.
If you need to move the trampoline, two people should be used at least. All connector points should be
wrapped secured with weather resistant tape, such as duct tape. This will keep the frame intact during the
move and prevent the connector points from dislocating and separating. When moving, lift the trampoline
slightly of the ground and keep it horizontal to the ground. For any type of other move, you should disassemble
the trampoline.
Photo 2
Photo 3
Publicidad
