Publicidad
Idiomas disponibles
Idiomas disponibles
Important:
1) Springs must be attached the right way around and fully inserted into the holes along the top of the frame.
2) It is easier to place one hand on the frame and pull the spring towards you.
3) Make sure that "a" is attached to the D-rings of the jumping mat and "b" is attached to the trampoline frame.
4) The placement of the next spring must be on the opposite side of frame, then center adjacent, then opposite. It
must be done this way so the tension of the spring is spread equality.
5) To ensure that you have started to fit the bed correctly, please count the spring holes in between each top rail to
make sure that you have the same number of spring holes in the top rails.
6) Make sure that the D-rings on the bed, match the number of holes along the top rails.
7) If you notice that you have skipped a hole and D-ring connection, recount, remove and adjust accordingly.
7. Lay Frame Cover (A) on outer edge, so springs are covered. It should be fitted like a shower cap. It should be
fitted like a shower cap. Please ensure it covers all metal parts.
8. Tie the strap located at the under side of the Frame Cover to frame. Do not tie them to the springs.
Publicidad
