Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
TO
REDUCE
THE
RISK
OF
FIRE
OR
ELECTRIC
SHOCK,
DO
NOT
EXPOSE
THIS
APPLIANCE
TO
RAIN
Oh
MOISTURE.
A
A
o
RISK OF ELECTRIC SHOCK
DO NOT OPEN
~
A
"CAUTION:TO
REDUCE
THE RISK OF
ELECTRIC
SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE
PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL."
Explanation
of Graphical
Symbols:
The lightning
flash with arrowhead
symbol,
A
within an equilateral
triangle,
is intended
to
alert the user to the presence
of uninsulated
"dangerous
voltage"
within the product's
en-
closure that may be of sufficient
magnitude
to
constitute
a risk of electric shock to persons.
A
The exclamation
point within
an equilateral
triangle
is intended
to alert the user to the
presence
of important
operating
and mainte-
nance (servicing)
instructions
in the literature
accompanying
the appliance.
PRECAUTIONS
Read the Operating
Instructions
carefully
and completely
before
operating
the unit, Be sure to keep the Operating
Instructions
for
future
reference.
All warnings
and cautions
in the Operating
Instructions
and on the unit should be strictly followed,
as well as
the safety suggestions
below.
Installation
1
2
3
4
5
6
Water and moisture
— Do not use this unit near water, such
as near a bathtub, washbowl,
swimming
pool, or the like,
Heat — Do not use this unit near sources
of heat, including
heating vents, stoves, or other appliances
that generate
heat.
It also should
not be placed
in temperatures
less than 5°C
(41 'F) or greater than 35°C (95"F).
Mounting
surface
— Place the unit on a flat, even surface.
Ventilation
—The unit should be situated with adequate space
around it so that proper heat ventilation
is assured.
Allow 10cm
(4 in,) clearance
from the rear and the top of the unit, and 5 cm
(2 in.) from the each side,
- Do not place the unit on a bed, rug, orsimilarsurface
that may
block the ventilation
openings.
- Do not install the unit in a bookcase,
cabinet, or airtight rack
where ventilation
may be impeded.
Objects
and liquid
entry — Take care that objects or liquids
do not get inside the unit through the ventilation
openings.
Carts
and
stands
— When
placed
or
mounted on a stand or cart, the unit should
be moved with care,
Quick stops, excessive
force, and uneven
m
k
surfaces
may cause
the unit or cart to
3
overturn
or fall.
AL*
7
8
Condensation
— Moisture
may form on the CD pickup lens
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation
inside, it may not function
normally. Should this occur, leave the unit forafew
hours, then
try to operate again,
Wall or ceiling
mounting
— The unit should not be mounted
on a wall or c~ling,
unles;
specified
in the Operating
instruc-
tions.
Electric
Power
1
2
3
4
5
Power
sources
— Connect
this unit only to power sources
specified
in the Operating
Instructions,
and as marked on the
unit,
Polarization
— As a safety feature, some units are equipped
with polarized AC power plugs which can only be inserted one
way into a power outlet. If it is difficult orimpossibleto
insert the
AC power plug into an outlet, turn the plug over and try again.
If it still does not easily insert into the outlet,
please
call a
qualified service technician
to service or replace the outlet. To
avoid defeating the safety feature of the polarized
plug, do not
force it into a power outlet.
AC power
cord or car battery
cord
- When disconnecting
the power cord, pull out by the plug. Do
not pull the cord itself.
- Never handle the power plug with wet hands, as this could
result in fire or shock.
- Power cord should be routed to avoid being severely
bent,
pinched, or walked upon. Pay particular
attention to the cord
from the unit to the power socket.
- Avoid
overloading
AC power
plugs
and extension
cords
beyond their capacity,
as this could result in fire or shock.
Extension
cord —To
help prevent electric shock, do not use
a polarized AC power plug with an extension
cord, receptacle,
or other outlet unless the polarized
plug can be completely
inserted to prevent exposure
of the blades of the plug.
When not in use — Disconnect
the AC Dower cord from the AC
outlet if the unit will not be used for several
months or more.
When
the cord
is plugged
in, a small
amount
of current
continues to flow to the unit, even when the power is turned off.
Outdoor
Antenna
1
2
Power lines — When connecting
an outdoor antenna,
make
sure it is located away from power lines,
Outdoor
antenna
grounding
— Be sure the antenna svstem
is properly grounded to provi~e protection
against unex~ected
voltage surges or static electricity
build-up.
Article 810 of the
National Electrical Code, ANS1/NFPA 70, provides information
on proper grounding
of the mast, supporting
structure,
and the
lead-in wire to the antenna discharge
unit, as well as the size
of the grounding
unit, connection
to grounding
terminals,
and
requirements
for grounding
terminals.
Antenna
Grounding
According
to the National
Electrical
Code
)
(NEC ART 250 PART H)
NEC-NATIONAL
ELECTRICAL
CODE
2
ENGLISH
Publicidad
