Front panel
1
7
1. Carrying handle
5. LED panel
2. Command console
6. Metal grid
3. LED display
7. Rubber feet to place speaker on its side
4. Subwoofer/full range speakers
IV. Initial setup
Note: For your safety, read this manual and follow all safety instructions before using the product.
Charging the battery
1.Plug the USB-C charging cable into the speaker, and the other end to an adapter or Type A connector.
2
2. The LED charging indicator (on the top panel) will turn red while charging, and will turn off when fully charged
3. When the unit is not in use or switched off, it will automatically recharge the internal battery as long as it
3
remains connected to utility power.
5
Powering on the unit
1. Turn the main volume knob on the top clockwise.
2. Connect audio input devices first. Make sure all input sources such as microphones, or digital media
6
players are turned off and volume settings are set to their lowest settings (zero).
3. Slowly turn the volume clockwise until the sound output is at the desired level. If there is no sound, check
to make sure the source equipment is providing audio output
Using the wired microphone
1. Plug the microphone and switch it on. The speaker will detect the device automatically.
2. Adjust the mic knob to increase or decrease the Microphone output.
3. When not in use, switch the microphone off.
V. Operating modes
4
1. Auxiliary playback
a) Use a 3.5 mm auxiliary audio cable to connect the speaker to external audio devices through the
Auxiliary input located on the top panel.
b) If the speaker is not set to LINE, press the MODE button until the corresponding input mode is found.
c) When the LINE indicator is displayed on the screen, you can start streaming audio directly from
compatible multimedia sources.
d) Please note that the forward and backward song selection is not available in this mode.
2. USB/SD
playback
TM
a) Insert an SD
card or USB memory stick into the corresponding slot.
TM
b) The device will automatically play any file in audio format stored on the memory.