Publicidad
Idiomas disponibles
Idiomas disponibles
2. FM Radio
1.Press the MODE button briefly to toggle through the available audio sources and select FM.
2. Press and hold the PLAY/PAUSE button to start scanning for radio stations automatically, in the
frequency range between 87.5 and 108.0MHz.
3. Once the search is complete, the unit will save active stations automatically.
4. Use the
and
buttons to select stored channels.
Note: An optimal radio signal will depend on device location and the proximity of radio stations.
VI. Advanced operation
Pairing the speaker with wireless devices
Note: Before installing this product, please make sure your device is compatible with Bluetooth
1. Enable the Bluetooth
feature on the selected source and set it to discover the wireless speaker.
®
2. Place your wireless device and the speaker not more than one meter away from each other.
3. Next, cycle to the Bluetooth
feature on the speaker by pressing the MODE button found on the media
®
panel and select it as the input source. The blue indicator blinks fast on the display to indicate that the
speaker has entered into the pairing mode.
4. Once the speaker appears listed (KLS-100) under the newly found Bluetooth
device, it will ask if you want to pair with it.
5. Accept by pressing Yes or Ok. If you have a lower Bluetooth
passkey 0000 (4 zeros).
6. When pairing is successful, the blu icon stops blinking indicating that the wireless connection has been
established. If after 60 seconds the pairing process fails, please repeat steps 1 through 5 described above.
7. You can now start streaming audio through the speaker wirelessly from your favorite Bluetooth
enabled devices.
8. The speaker will re-pair automatically to the memorized device when the BT mode is selected on the unit
after being turned off and on again.
TWS connection
TWS connection allows two speakers to be linked at the same time, to amplify the sound.
1. Place the two speakers near each other, not further than 1 meter between them.
2. Turn ON both units and they will enter directly into "Bluetooth mode".
3. On one of the units (this becomes the master unit), press and hold the Play/TWS button now paired.
4. Enable the Bluetooth mode on your device and search for the KLS-100 speaker to connect (pair) to it.
5. Perform the audio test (from the smartphone music library or YouTube) and ensure audio is playing on both
speakers at the same time.
6. To unpair TWS mode, press and hold the Play/TWS button until a tone is generated by both units. Units are
now unpaired from TWS mode.
.
®
devices of your wireless
®
version, you may be prompted to enter the
®
-
®
VII. Troubleshooting
Issue
Possible cause
The speaker is not connected properly
The display fails to turn on
Power switch is not on
Volume adjusted at the lowest level
No sound
Wrong input mode selected
Incorrect speaker connection.
Master volume is too high
Distorted sound
The speaker is damaged
Solution
Check the connection and plug in the
AC adapter
Adjust the volume to a comfortable listening level
Choose the playback mode based on the
external source being used
Check all connections and try again
Decrease the master volume.
Check or replace the speaker
Publicidad
