Worx WR206E Manual De Instrucciones página 21

SYMPTOM CAUSE
The direction of the charging
base is incorrect.
Landroid Vision can not There are obsacles in front of the
find the charging base. charging base.
The QR code is sheltered.
Environmental influences.
Landroid Vision cannot
correctly dock with the
Poor connection caused by
charging pile.
debris on the charging strip.
The green light on the
charging pile turns The charging base is overheating
on before charging is or overcooling.
complete.
Obstacles, such as twigs and
branches may be lodged under
Landroid Vision.
Landroid Vision wheels
skid or repeatedly slip.
The lawn is too wet.
Low grip of Landroid Vision drive
wheels.
The slope is steeper than 30%
(17
Landroid Vision slips out
of its working area.
Recognition error.
There is grass whose height is
higher than 15 cm.
The grass is taller than 15 cm.
Landroid Vision frequently
There is grass around suspen-
collides.
ded objects such as a hanging
fence or a slide.
Landroid Vision operative
system crashes when Software or display fault.
charging or on standby.
Landroid Vision fails to charge
due to over temperature pro-
Landroid Vision shuts
tection and is powered off.
off when docking in the
charging pile.
Poor connection.
There are continuous obstacles
in the working area.
Landroid Vision stops in
The cutting height is set too low
the working area.
for the length of the grass or the
grass is too dense.
).
o
SOLUTION
Make sure Landroid Vision dock right towards the charging base
and departures in anti-clockwise direction.
Please remove the obstacles within the 2 m in front of the char-
ging base.
Make sure the QR code is clear and that there is nothing directly
on it or above it.
Restart Landroid Vision.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
Place the charging base in a shady area or wait until it reaches
the normal temperature.
Remove objects from underside of Landroid Vision.
Exclude the wet or soft ground areas by using the magnetic strip
or by creating a non-grass pathway that is more than 5 cm wide
until the lawn is dry again.
Please check the wheels are clean and free of mud in order to
have the maximum grip possible.
Exclude the sloped area by using the magnetic strip or by cre-
ating a non-grass pathway that is more than 5 cm wide directly
beside the slope.
Remove the obstacle if there is one. Using the magnetic strip or
by creating a non-grass pathway that is more than 5 cm wide on
the lawn edge ensure that the mower functions correctly.
Trim the grass to below 15 cm. Lay magnetic strips or set up a 5
cm non-grass pathway if there are steps, cliffs or a pond below
the grass.
Trim the grass to below 15 cm.
Lay magnetic strips or set up a 5 cm non-grass pathway around
the area.
Restart Landroid Vision.
Place the charging base in a shady area or wait until the tempe-
rature has cooled down.
Check the LED light on the charging pile. Check the connection
between the contact pins located on the charging pile and the
charging strip.
Lay magnetic strip or by creating a non-grass pathway that is
more than 5 cm wide around the obstacles.
Raise the cutting height and then gradually lower.
EN
21