Worx WR206E Manual De Instrucciones página 22

SYMPTOM
Landroid Vision flips over.
Landroid Vision fails to
connect to the internet.
The software upgrade
fails.
Your Landroid Vision
beeps when you are
adjusting "month / hour /
minute"
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice.
Remove the used battery pack from the appliance and dispose of it at the most convenient recycling facility. If in doubt, consult
your local environmental protection department.
22
CAUSE
There is an inclined obstacle on
the lawn.
Please check your router has the
correct settings.
Please check whether the router
is disconnected or WIFI SSID is
changed.
The Wi-Fi signal is weak.
The battery level is less than
50%.
It is normal.
SOLUTION
Exclude the obstacle from Landroid Vision's working area.
Make sure your router is 2.4GHz or 5GHz. If your router has two
settings, please enable the 2.4GHz or 5GHz band.
Make sure your router is set to 802.11 mode and wireless setting
is b/g/n mixed.
Make sure your router has the SSID Broadcast function enabled
when you connect the machine with the App.
You can close it after you connect successfully.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to connect Landroid
Vision to the new network.
If you have a "Fritz! box" router, please make sure activate
"Allow communication between devices in same network" in the
settings.
Make sure the router is connected and WIFI SSID is correct.
Move closer to the router to strengthen the signal.
Place Landroid Vision on the charging station or ensure that the
battery level is above 50%.
Anticlockwise the to adjust.
EN