Hiyasu ASE7Ui-P Manual De Funcionamiento página 31

Operation instructions
Operation modes
Selecting mode
Each time MODE button is pressed, the operation mode
is changed in sequence:
COOLING DRY
Heating mode is NOT available for cooling only air conditioner.
FAN mode
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
Auto
At "FAN ONLY" mode, only "High","Medium" and "Low" are available.
At "DRY" mode, Fan speed is set at "AUTO" automatically, "FAN" button
is ineffective in this case.
Setting temperature
Press once to raise temperature setting by 1℃
Press once to lower temperature setting by 1℃
Range of available set temperature
*HEATING, COOLING
DRY
FAN
Note: Heating mode is NOT available for cooling only models.
Press button, when the appliance receives the
signal, the RUN indicator of the indoor unit lights up.
SWING, SMART, TIMER ON, TIMER OFF, CLOCK, SLEEP and SUPER operation modes will be
specified in the following pages.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
Wait 3 minutes before restarting the appliance.
FAN ONLY HEATING
High Medium
Low
18℃~32℃
-7 ~ 7
unable to set
ONLY
Turning on
ON ON
OFF OFF
ON/OFF
MODE FAN
1
SWING SLEEP SUPER
SMART
IFEEL DIMMER
TIMER ON TIMER OFF CLOCK
3
29