Publicidad
Idiomas disponibles
Idiomas disponibles
To prevent personal injury, always disconnect plug from power source before per-
forming any assembly, adjustment, or repair.
Power Switch
(Fig. 53, Fig. 54)
To turn saw on: flip the Clear Switch Cover 92 up,
and press the Green ON (I) Button 93.
To turn the saw off: push the Red OFF (0) Stop
Paddle 94.
To prevent unauthorized use, the Power Switch 1
can accommodate a padlock with a 1/4" (6.3 mm)
diameter shackle (not provided with the table saw).
Lock the switch as follows:
1. Flip the Clear Switch Cover 92 down.
2. Press the Clear Switch Cover 92 and Red Stop
Paddle 94 to align the holes.
3. Secure the switch with a padlock thru both
sides of the switch. Padlock (not provided with
the saw) must have a 3/16" or 1/4" (4.5 or 6
mm) diameter shackle.
Fig. 53
Fig. 54
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 39
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 39
Basic Table Saw Operations
92
92
93
93
94
94
-39-
Using the Smart Guard System
(Fig. 55)
The Bosch Smart Guard System 11 has been de-
signed for modularity, enabling the use of multiple
combinations of the three main components: the
Riving Knife 25, the Barrier Guard Assembly 26,
and the Anti-Kickback Device 27.
The Riving Knife 25 can be quickly adjusted to
any of three positions for different applications:
through cut (high), non-through cut (middle), and
dado (lowest).
The three primary components of the Smart Guard
blade guarding system are designed for rapid at-
tachment, adjustment, and removal without addi-
tional tools.
If you remove any Smart Guard System 11 compo-
nents to complete a cut, immediately reinstall them
when finished. (See "Attaching the Barrier Guard
Assembly" on page 19 for detailed installation
instructions.)
Always remember that the best accident prevention
is the operator's use of common sense and alert-
ness at all times when using the table saw.
Fig. 55
12
12
27
27
11
26
26
25
25
4/20/2023 11:23:42 AM
4/20/2023 11:23:42 AM
13
13
Publicidad
