MTD 450 Serie Manual Del Operador página 7

Attaching The Chute Deflector
3. a. Removethe wingknobs fromeach sideof the lower
impellerhousing.
b. Remove the hexlock nut,spacers,andhex boltfrom
the topof theimpellerhousing.SeeFigure3-3.
4. a. Align the chutedeflectorin positionon the
dischargeopeningand inserthex boltwith spacer
throughhingeon chutedeflector(spacersfit inside
of hinges).See Figure314.
b. Placesecondspaceroverhex bolt insideother
hingeand securewith hex lock nut.
c. Securebothsides of chutedeflectorto impeller
housingusingwingknobspreviouslyremoved.
Attaching The Chipper Chute
(Model Series 460)
5. a. Removethe threecuppedwashersand hexnuts
from weldstudsaroundthe openingon the side of
the impellerhousing.See Figure3-5.
b. Removethe hexbolts,flat washers,and lock nuts
from the two holeson the upperend of the support
brace.
6. a. Align the chipperchute overthe weldstuds, sothe
slot in the bottomof the chuteis facing down.
b. Securechipperchute with the threecupped
washers(cuppedsideagainstthe chipperchute)
and hexnuts previouslyremoved.Do nottighten
the nuts at this time. See Figure316.
Figure 3-4
f
Fgure 3=5
/
/
/
/ /
/
//
/
/
.......... 1, /
/
/J
/
/
/
//
/
/
Figure 3=6
Your Chipper
Sh redder
IMPORTANT
This unit is shipped
without gasolineor
oil in the engine. Be
certain to service
enginewith gasoline
and oil as instructed
in the separate engine
manual before operat-
ing your machine.
NOTE: All references
in this manual to the
left or right side of
the chipper shredder
is from the operating
position only. Excep-
tions, if any, will be
specified.
NOTE: This Operators
Manual covers a range
of product specifica-
tions for various
models. Characteristics
and features discussed
and/or illustrated in this
manual may not be ap-
plicable to all models.
MTD LLC reservesthe
right to change product
specifications, designs
and equipmentwithout
notice and without
_ncurringobligation.
7