Bobbin Winding - Sears Kenmore 385.16520000 Manual De Instrucciones

° Bobbin winding
[] Pull the handwheet out to the right°
[] Draw thread from the spool°
[] Guide the thread around the thread guide.
(_) For horizontal spool pin
® For additional spool pin
F4]Thread through the hole in the bobbin from the inside to
the outside.
[] Put the bobbin on the bobbin winder spindle°
[] Push the bobbin to the right.
[] With free end of the thread held in your hand, depress
the foot control. Stop the machine when it has made a
few turns and cut the thread close to the hole in the
bobbin.
[] Depress the foot control again. When the bobbin is fully
wound, it stops automatically, Return the bobbin winder
to its original position by moving the spindle to the left
and cut the thread as shown,,
[] Push the handwheel in. The machine witl not function
until the clutch is engaged,
" The machine does not function until the clutch is
engaged.
NOTE:
Position of the bobbin winder stopper is adjustable for the
required amount of thread on the bobbin (example: 1/2
full or full etc.). Use a screwdriver and loosen the screw
one turn or less so that you can adjust the position of the
bobbin winder stopper. Do not take out the screw all the
way,,
[]
[]
f
[]
[]
®
[]
[]
\
J
J
J
22