Bresser TemeoTrend SQ Instrucciones De Uso página 23

5. Press the ALARM SET button again to save
the settings and exit the setting mode.
Pay attention: The alarm time is set and
the alarm call will automatically follow at the
set time, if the corresponding symbol
displayed in the display.
Activate the alarm
1. Set the alarm as previously described.
2. Press the ALARM SET button (Fig. 1, 2)
in the display mode just once to activate AL.
The corresponding symbol is displayed in the
display. By pressing the button again, the
alarm is deactivated.
Using the snooze function
1. If no button is pressed while the alarm is
sounding, the alarm automatically turns off.
Press the SNOOZE/LIGHT button when
the alarm is sounding so that the alarm
is interrupted and the snooze function is
activated. The alarm symbol will flash.
2. If the snooze function is activated, a four-
stage wake-up call takes place in a time period
interval of 5 minutes. The duration of the alarm
L700X40XMSP1215BRESSER.indd 23
is approximately 120 seconds.
3. The snooze function can only be deactivated
by pressing the ALARM SET button (Fig. 1, 2).
Weather forecast
is
(Not applicable to TemeoTrend SQ/ Type. No.
70-04400)
The integrated barometer registers the
atmospheric air pressure. Based on these
values, a forecast of the weather for the next
12-24 hours will be created.
Pay attention: The accuracy of the weather
forecast is about 70-75%. The weather
forecast is always for the next 12-24 hours
and does not necessarily take into account
the current weather conditions.
Display of the channels
1. As standard, channel 1 appears on the
display. Press the CH + button (Fig. 1, 3)
in the display mode to switch between the
individual channels.
2. Press and hold down the CH+ button for
about 2 seconds to activate the automatic
channel-change display.
DE
GB
FR
NL
ES
IT
23
14.12.15 13:2