Two Point Mode Procedure - CARLO GAVAZZI CA30CAF BPA2IO Serie Manual De Instrucciones

2) Dynamic teach command sequence
#71 "SP1 dynamic teach start"
#72 "SP1 dynamic teach stop"
#64 "Teach apply" (optional command)
3) Two value teach command sequence
#67 "SP1 two value teach TP1"
#68 "SP1 two value teach TP2"
#64 "Teach apply" (optional command)
Command Sequence
1) "SP1 Two value Teach TP1"
2) "SP1 Two value Teach TP2"
3) "Teach Apply"

2.5.2.2. Two point mode procedure

1) Two value teach command sequence:
#67 "SP1 two value teach TP1"
#68 "SP1 two value teach TP2"
#64 "Teach apply" (optional command)
#69 "SP2 two value teach TP1"
#70 "SP2 two value teach TP2"
#64 "Teach apply" (optional command)
Command Sequence
1) "SP1 Two value Teach TP1"
2) "SP1 Two value Teach TP2"
3) "Teach Apply"
4) "SP2 Two value Teach TP1"
5) "SP2 Two value Teach TP2"
6) "Teach Apply"
18
Rev.00 - 06.2018 | CA18/CA30 Capacitve sensors with IO-Link interface | © 2018 | CARLO GAVAZZI Industri
SSC
Sensor
SSC
Sensor
Sensing distance
Sensing distance