Two Point Mode Procedure - CARLO GAVAZZI PD30ETB BP IO Serie Manual De Instrucciones

2.6.2.2. Two point mode procedure

1) Two value teach command sequence:
Buttons are found in menu: "Teach-in SSC1" or "Teach in SSC2" -> "Teach-in Two value SSC1"
or "Teach-in Two value SSC2"
1. Move the target to the position for SP1 TP1
2. Move the target to the position for SP1 TP2
3. Move the target to the position for SP2 TP1
4. Move the target to the position for SP2 TP2
5. Press Teach Apply
6. QoT is shown in "Quality of Teach" e.g. 100 %
2) Dynamic teach command sequence:
Buttons are found in menu: "Teach-in Dynamic SSC1" or "Teach-in Dynamic SSC2" -> "Teach-in"
1. Move the target to the position for SP1
2. Move the target to the position for SP2
3. Teach-in Result.Teach-in state = e.g. "SUCCESS"
4. QoT is shown in "Quality of Teach" e.g. 100 %
30
Rev.00 - 06.2021 | MAN PD30ETB IO-Link EN | © 2021 | CARLO GAVAZZI Industr6
A. Press "Teach SP1 TP1"
B. "Teash-in Result.TeachPoint 1 of Set Point 1" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP1 TP2"
B. "Teash-in Result.TeachPoint 2 of Set Point 1" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP2 TP1"
B. "Teash-in Result.TeachPoint 1of Set Point 2" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP2 TP2"
B. "Teash-in Result.TeachPoint 2 of Set Point 2" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Teach-in Result.Teach-in state = e.g. "Success"
Sensor
SSC
TP2
ON
A. Press "Teach SP1 Start ".
B. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
C. Press "Teach SP1 Stop "
D. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP2 Start ".
B. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
C. Press "Teach SP2 Stop "
D. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
SP2 SP1
TP1 TP2 TP1
OFF
Sensing distance