Publicidad
Idiomas disponibles
Idiomas disponibles
SETTINGS
Hint: Before starting initial setup you must connect antenna.
This section describes the initial settings when you
first turn on the power after purchase. The initial
setting items are shown below.
LANGUAGE SELECTION
You can select the menu language displayed on
the screen among English, Spanish and French.
,, AUTOSCAN (TV/DTV)
(Select "Air" when using antenna)
The channels broadcasted in TV and DTV are
automatically scanned and memorized. Only the
receivable channels in the area where this TV is
used will be memorized.
* AUTOSCAN (CATV)
(Select "Cable"
when using RF/Incoming
cable)
The channels broadcasted in CATV are automati-
cally scanned and memorized.
POWER
_ _:_ _ii_i!!!_
1 After making all the necessary connections, turn
on this TV.
2
Press [POWER]. Initial Setup menu will appear.
,, This operation may take a few moments.
,, If Initial Setup menu does not appear press
and hold [ENTER] for 3 seconds, initial setup
will appear then proceed to step 3. If you have
already turned on this TV before, refer to
"LANGUAGE
SELECTION" on page 17 to
select a language for the on-screen displays.
3 Select your language using [A/T],
press
[ENTER].
When you first turn on the power, the following
screen is displayed.
4 Select destination of ANT IN jack using [A/_'],
press [ENTER].
5 Autoscan will start automatically.
,, When scanning is completed, the smallest
memorized channel will be displayed.
NOTES:
. If you do not operate this TV for more than 45 seconds
while initial setup, the message boxes start to move to the
lower left-hand corner of the screen. This is for saving you
screen from bum-in. Press any key except [POWER]
to can-
cel it.
° The initial Autoscan function can be executed for either "Air"
or "Cable" only once. When you change the connection
(Air/Cable),
set the "Autoscan" again. (Refer to page 14.)
. If you connect
cable system
directly,
contact
the CATV
installer,
. When the scanning is not completed,
Helpful Hint will be
displayed every time you turn on the power. If you have
previously
registered
channels when this screen appears
you can select a channel with number buttons.
. Support hotline is provided
on the front page of this
manual.
09
(5
Z
UJ
09
..J
E
z
m
uJ
09
t_
0
z
0
t_
uJ
t_
n
The Antenna Confirmation
will be displayed in
the selected language after you press [ENTER].
EN
Publicidad
