Publicidad
Idiomas disponibles
Idiomas disponibles
ilililililililililililililililililililililililililililili
ii_i!_i_ii!_!i_ii_i_ii_ii_iii_i!_i!_i!_i_i_i_i_i_i_i_i_i_
i ANNEL
SETTINGS
If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area
after the initial setting, you need to perform
Autoscan again. This function lets you easily select
the receivable channels with [CH A/T] and the TV
memorizes them even if you switch wires.
3
For TV channels, using [A/T],
select "Air".
For CATV channels, select "Cable".
,, Press [ENTER].
Scanning and memorizing the channels auto-
matically starts.
NOTE:
* Make sure if the TV is connected
to antenna or cable.
1 Display the setup screen.
, Press [SETUP].
The following setup screen is displayed.
2
Select "CHANNEl"
and press [ENTER] to con-
firm.
,, Using [A/T],
select "Autoscan".
,,When the scanning and memorizing are com-
pleted, the smallest memorized channel in the
broadcasting will be displayed.
NOTES:
° tfyou do not operate this TV for more than 45 seconds
while initial setup, the message boxes start to move to the
lower left-hand
corner of the screen. This is for saving your
screen from burn-in. Press any key except [POWER] to can-
cel it.
. If you connect
cable system directly,
contact
the CATV
installer.
. If you press
[POWER]
or [SETUP]
during
Autoscan,
this
setting
will be canceled.
. If there is no reception
connected
orpoor
signal is detected,
a Hint will appear on screen once scanning stops.
,, Press [ENTER].
EN
Publicidad
