Publicidad
Idiomas disponibles
Idiomas disponibles
EPARATION
FOR USE
This section describes how to connect this TV to reception and other sources.
NOTE:
Be sure that antenna or cable is connected
properly
before plugging
the power cord.
[ANTENNA
CABLE CONNECTION]
1) When connectinq TV to antenna
Connect the RF cable or antenna cable on your home outlet to the ANT. IN jack of this TV.
2) When connectinq TV to RF/Incominq cable (without box_
Connect the RF cable or incoming cable on your home outlet to the ANT. IN jack of this TV.
Rear of this TV
NOTES:
* For your safety and to avoid damages
to the unit, unplug the antenna cable from the ANT IN jack before moving the unit.
°ff you use an antenna
in order to receive
analog
TV, the same antenna
generally
will work for DTV reception.
Outdoor
or attic antennas
will be more effective
than set-top
versions.
° To easily switch between
antenna and cable wires, you can purchase
'_Antenna Selector" commercially
available.
°ff you connect
cable system
directly,
contact
the CATV installer:
*Once connections
are completed,
turn on the TV and begin initial setup.
Channel
scanning
is necessary
for the TV to memorize
all available
channels
in your area if using
antenna
or RF/Incoming
cable. (Refer to "iNiTiAL
SETTINGS" on page 13.)
[CONNECTION
TO CABLE/SATELLITE
BOX]
1) Connect the antenna cable on your home outlet to the input jack of the CABLE/SATELLITE
box.
2) Use the corresponding
cable to connect the ANT. IN jack of this TV and the output jack of the
CABLE/SATELLITE
box.
*Required cables in 2) and connecting methods differ depending on the CABLE/SATELLITE box. For more informa-
tion, please contact the cable/satellite provider.
Satellite
antenna
m
ii i_i! _iii¸i i/iiii i _i iiiii_ iiiii_ _ iii) i i_ _ iii iii
CableTV
ii_ i'0r;:_i
si0no,...
CABLE Box
or SATELLITE
Box
_ Cables not included
Near of thisTV
EN
Publicidad
