Vaporesso XROS 3 NANO Instrucciones De Uso página 3

ENGLISH
USER INSTRUCTIONS
1. Install & Replace the Pod
Pull out the pod from the battery and install the
new one.
*If it's the first time using the device, please tear
off the sticker of the pre-installed pod.
2. Fill the E-liquid（Refer to FIGURE 1）
Snap off the mouthpiece then squeeze the e-liquid
through filling slot. After filling, put the mouthpiece
back and make sure it's shut firmly.
*If it's the first time filling the e-liquid, please wait
5 minutes for the coil to prime.
3. Adjust Airflow（Refer to FIGURE 2）
There is an airflow control toggle on the side of the
battery. Adjust the toggle according to your vaping
habits for different airflow effects.
4. Start Vaping
The device is draw-activated. Inhale through the
mouthpiece and exhale to start vaping.
5. Check the Battery Level
The LED indicator will stay in green/blue/red color to
show the battery level after vaping or inserting the
pod.
Battery Level
70%~100%
30%~70%
0~30%
LED Color
Green
Blue
Red
6. Charging
Please use the in-box Type-C cable to charge the
device. The LED indicator will stay in green while
fully charged.
PROTECTIONS
Low Resistance/Short-circuit/High Temperature: The
red indicator will flash 5 times and the device will
stop working.
No Load/High Resistance: The current battery level
indicator will flash 5 times and the device will stop
working.
Low Voltage/Over Discharging: The red indicator will
flash 3 times and the device will stop working.
Over Charging: The green indicator will stay on and
the device will stop charging.
Overtimes(8s): The device will stop working and the
LED indicator will flash in green-blue-red.
CAUTIONS
1. Do not leave the charging device unattended.
2. Do not drop, throw or abuse your device, which
may cause damage.
3. Please use a standard USB output charger with
proper charging current and voltage range.
4. Keep away from the water or any flammable gas,
liquid .
5. Do not expose the device to direct sunlight, dust,
moisture or mechanical shock.
6. Do not expose the device to extreme temperature.
(Recommended temperature range: -10~60℃