Publicidad
9. Wait until water stops flowing from the nozzle before removing the cup.
Note: the coffee maker will store the last settings of water volume.
4.4 Preparing drinks using steam
Steam can be used to froth milk for preparing a capuccino, caffe latte, or for heating up
liquids.
1. Place a container underneath the steam outlet nozzle (3).
2. Touch the Power icon (a) to switch the coffee maker on. Wait until automatic rinsing
process is finished.
3. Touch the icon (d). Indicator will light up.
4. Touch the icon (d) again. Heating process for steam preparation will start.
5. During preparation, indicator of the icon will flash.
6. Touch the icon (d) to stop preparation at any time.
7. Once preparation process has finished, all the indicators of the icons will light up per-
manently.
8. Wait until steam stops flowing from the nozzle before removing the container.
Note: if you want to change the amount of steam to be dispensed, please refer to section
3.3 Customization of water quantity adjustment.
5. MAINTENANCE AND CLEANING
5.1 Cleaning the drip tray and grounds collector
When the drip tray (4) is full, the red float (5) will become visible through the grill, showing
that the tray should be emptied and cleaned.
When the coffee grounds collector is almost full (6 coffees without cleaning), indicator
light of the icon (k) will light up showing that grounds collector should be emptied and
cleaned. It will be allowed to make 2 more coffees until it becomes mandatory to clean the
grounds collector which is indicated with the flashing of the warning.
For cleaning, proceed as indicated below:
1. Remove the tray by pulling it towards you. Along with the tray, grounds collector (11) will
be taken out as well.
2. Remove grounds collector. Empty the drip tray and the collector and wash them under
the tap.
3. Place ground collector on the drip tray again. Make sure it is fitted correctly. Once more
than 10s have passed, the indicator of the icon (k) will flash and the warning will light up,
showing that the container is clean and you can place it again. The coffee counter will be
restarted.
4. Place ground collector on the drip tray again. Make sure it is fitted correctly.
5. Insert the drip tray into the coffee maker. Make sure it is fitted correctly. The indicator of
the icon (k) and warning will turn off.
60
Publicidad
