Publicidad
be purchased from after sales service or specialist shops (see section "Accessories"). It is
recommended to perform the cleaning if the coffee maker has not been used for a long time.
Proceed as indicated below:
1. Make sure that the coffee maker is switched on and water tank is full.
2. Place a container (capacity about 1 litre) underneath the coffee outlet nozzles. Height of
coffee outlet nozzles can be adjusted moving them upwards and downwards.
3. Open up the ground coffee container lid (13) and pour a cleaning tablet. Then, close the lid.
4. Touch the icon (h) for 3 seconds. The indicator will light up.
5. Touch the icon (h) again: Cleaning process will start.
6. During the cleaning process (about 18 minutes), the indicator of the icon (h) will flash.
NOTE: Once about 60ml of the solution has been dispensed, the coffee maker will remain
stopped for 15min so that the tablet takes effect. The icon (h) will remain flashing. NOTE:
Once the tablet has been added, the cleaning process must be carried out completely so
that no residues of the degreasing agent are left behind.
7. Once cleaning process has finished, all the indicators of the icons will light up permanent-
ly. The coffee maker is ready to be used again.
5.3 Cleaning ground coffee inlet
After a long period of use, internal walls of ground coffee inlet could get blocked due to
coffee powder residues stuck on them. It is very important that inlet is cleaned frequently.
Proceed as indicated below:
1. Remove the brewing unit as indicated in section 5.3 "Cleaning the brewing unit".
2. Open ground coffee compartment lid (13). Use a brush to remove the coffee powder
residues stuck on inlet wall. Residues will be collected in the drip tray.
3. Insert the brewing unit.
5.4 Descaling the coffee maker
Important: To keep the right function of your coffee maker for a long time, it is very im-
portant to perform the descaling process after a period of time.
Indicator of the icon (i) will light up showing that descaling process should be carried out.
The process duration is about 40 minutes.
Important: if water filter is assembled, remove it before starting descaling process.
If the water filter has reached the end of its recommended use period (2 months), it is advi-
sable to replace it after completing this descaling process. Please refer to sections "Water
filter" and "Activating water filter".
Proceed as indicated below:
1. First stage: removing the scale
a) Make sure that the coffee maker is switched on.
b) Remove the water tank (6), empty it and pour the recommended dose of descaling so-
lution (250 ml).
Descaling solution is supplied depending on the model or may be purchased from after
sales service or specialist shops (see section "Accessories").
c) Fill the tank with water up to the "MAX" level mark.
d) Place a container (capacity about 1 litre) underneath the steam and coffee outlet nozzles.
Height of coffee outlet nozzles can be adjusted moving them upwards and downwards.
62
Publicidad
