Publicidad
Drip tray fills up quickly.
Indicator of the icon
(k) flashes although
grounds collector has
been emptied.
The indicators of icons (l)
and (e) light up.
Brewing unit cannot be
removed.
Brewing unit cannot be
inserted.
Loud noise coming from
the grinder.
The coffee maker makes a
pumping sound.
The drink is not hot
enough.
66
Automatic rinsing process
of the system.
Internal counter has not
been reset.
Water tank has emptied
while the drink was being
prepared. Air has come into
the water circuit.
Brewing unit blocked.
Brewing unit not placed in
the right position.
Some kind of foreign object
inside the grinder.
Water is being pumped
into the system.
Selected temperature
is low.
Cup is cold or drink prepa-
red with cold milk.
This is normal. As soon as the
red float is visible, remove
the drip tray and empty it
(see "Emptying the drip tray"
section).
Remove the drip tray again.
Wait some seconds until the
indicator (k) flashes and the
indicator (l) lights up. Then,
insert the drip tray.
Empty the coffee grounds
collector while the machine is
switched on.
Fill the water tank. Touch the
icon (e). Air removing process
will start automatically.
Unplug the coffee maker for
about 30s and turn it back on.
Then, try to remove it once
again.
Pay special attention to
insert the brewing unit in the
guides on its bottom. Then
push it inwards. (see section
5.3 "Cleaning the brewing
unit" step 9). Another possi-
ble solution would be: Unplug
the coffee maker for about
30s and turn it back on. The
system should be positioned
to allow installation of the
brewing unit.
Contact your after sales
service.
This is normal.
Select a higher temperature
(see section "Selecting the
temperature").
Preheat the cup or use
warm milk.
Publicidad
