GE PGP990 Manual Del Usuario página 28

Installation Instructions
INSTALL THE COOKTOP
INSTALL THE COOKTOP
Lower the cooktop into the countertop opening,
guiding it into position.
[] SECURE THE COOKTOP
Tighten the tie-down bolts to secure the cooktop
to the counter. For countertops less than Z" thick,
securely attach filler blocks of wood to the bottom
of the countertop where the tie-down bolts will be
tightened.
Filler wood block Tie-down
for countertops bolt through
less than l"thick cooktoptab
\\_ e e • • e
• e ® e •
e . • • o
ii®ll
[] OPTIONAL: ATTACH A BLOWER
TRANSITION DUCT
If using 6" round standard ductwork, attach
a blower transition duct. This 3V_"x ZO" rectangle
to 6" round transition duct is available at your
local building supply store.
_ Screw
(on other side)
Install the transition duct to the blower
outlet. Secure all joints with duct tape
to assure an airtight seal.
28
[_] CONNECT THE DUCTWORK
Connect the ductwork prepared earlier
to the blower transition duct.
I_1 ELECTRICAL CONNECTION
Electrical requirements:
120-volt, 60-Hertz, individual, properly grounded
branch circuit protected by a 15-amp circuit
breaker or time-delay fuse.
GROUNDING
IMPORTANT: (Please read carefully.)
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with
a standard three-prong grounding wall receptacle
to minimize the possibility of electric shock hazard
from this appliance. The customer should have
the wall receptacle and circuit checked by a
qualified electrician to make sure the receptacle
is properly grounded and has correct polarity.
Where a standard two-prong wall receptacle
is encountered, it is the personal responsibility
and obligation of the customer to have it replaced
with a properly grounded three-prong wall
receptacle in accordance with the National
Electrical Code.
Do Not, Under Ang Circumstances,
Cut Or Remove The Third (Ground}
Prong From The Power Cord.
Do not use an extension cord with this appliance.
Plug the power cord into an approved wall outlet.