Whirlpool 4GWED5500 Instrucciones De Instalación página 15

COMPLETE INSTALLATION CHECKLIST
Check that all parts are now installed. If there is an extra
■
part, go back through steps to see what was skipped.
Check that you have all of your tools.
■
Dispose of/recycle all packaging materials.
■
Check dryer's final location. Be sure vent is not crushed
■
or kinked.
For power supply cord installation, plug into an outlet.
■
For direct wire installation, turn on power.
Check that dryer is level. See "Level Dryer".
■
Remove film on console and any tape remaining on dryer.
■
Wipe dryer drum interior thoroughly with a damp cloth
■
to remove any dust.
Read the "Dryer Use" section in your "Use and Care Guide."
■
Set the dryer on a full heat cycle (not an air cycle) for
■
20 minutes and start the dryer.
If the dryer will not start, check the following:
■ Controls are set in a running or "On" position.
■ Start button has been pushed firmly.
■ Dryer is plugged into an outlet and/or electrical
supply is on.
■ Household fuse is intact and tight, or circuit breaker
has not tripped.
■ Dryer door is closed.
When the dryer has been running for 5 minutes, open the
■
dryer door and feel for heat. If you feel heat, cancel cycle
and close the door.
If you do not feel heat, turn off dryer, and check the
following:
■ There may be 2 household fuses or circuit breakers for
the dryer. Check that both fuses are intact and tight,
or that both circuit breakers have not tripped. If there
is still no heat, contact a qualified technician.
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.
REVERSE DOOR SWING (OPTIONAL)
(Models with side-swing doors only)
686 mm (27") Wide Model Side-Swing Door
1.
Place towel on dryer
Place towel on top of dryer to avoid damaging the surface.
2.
Remove bottom screws
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
3.
Lift door off top screws
Lift door until top screws in dryer cabinet are in large part of
hinge slot. Pull door forward off screws. Set door (handle side
up) on top of dryer. Remove top screws from dryer cabinet.
15