Craftsman 139.53962SRT1 Manual Del Propietário página 25

ONE-PIECE D OORS
Please readandcomply withthewarnings a nd
reinforcement instructions o ntheprevious page.
Theyapplytoone-piece doors also.
• Center t hedoorbracket o nthetopofthedoor,in
linewiththeheaderbracket a s shown. M arkeither
theleftandright,or thetopandbottom holes.
• Drill5/16"pilotholes andfastenthebracket w ith
hardware supplied.
If thedoorhasnoexposed framing, d rill3/16"pilot
holesandfastenthebracket w ith5/16"x1-1/2" lag
screws (notprovided) tothetopof thedoor.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SIZE
© ©
Nut 5/16"-18 Lockwasher 5/16"
Carriage BoIt
5/16"-18x2-1/2"
Header Wail
2x4 Support --Finished Ceiling--
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
Garage Door
HorizontaI and verticat
reinforcement is needed for
lightweight garage doors
(fibergIass, aIuminam, steel,
door with glass panel, etc)
(not provided)
___ _ Lock
Washer
5/16"-18
±
Q _ 5/16"
Door
For a door with no exposed framing,
or for the optional instaIlation, use
5/16"x1-1/2" lag screws (not provided)
to fasten door bracket.
Top of Door
(Inside Garac
Top Edge
of Door
Optional
Placement
Carriage Bott
_5/16"-18x2-1/2"
25