Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
- The machine will beep and its light indicators will turn on when there is not enough water in the
water tank. After refilling it, it will return to normal conditions.
- After finish using steam, hot water and brewing coffee functions cannot be used while the
machine cools down, wain until it enters standby mode.
- Empty the drip tray when the full-tray indicator raises.
5. CLEANING AND MAINTENANCE
•
Disconnect the device from the power supply and allow it to cool down completely before
cleaning.
•
Do not use abrasive cleaners or scouring pads as they could cause damage to the product's
surface.
•
Use a soft, dampened cloth to clean the outer part of the device.
•
Do not immerse the main body in water or other liquids.
•
Wash the water tank, drip tray and cup-holder tray regularly.
•
After using the steam function, the tube must be cleaned with a cloth immediately after.
Allow steam to be released to avoid possible blockages inside the tube.
•
If the steam tube is clogged, use a needle to unblock the conduct.
•
Turn the portafilter clockwise to detach it and empty all coffee residues inside it. Then, use
water and a cloth to clean it, do not wash it in the dishwasher.
•
Clean all parts with water and dry thoroughly before storing it or using the device again.
Cleaning mineral deposits
Mineral deposits built up in the unit might affect the machine's operating. It is important to
remove and clean them to keep the coffee machine operating efficiently. Quality of used water
and use will determine how often these deposits have to be cleaned.
It is recommended to carry out an Autocleaning cycle after each 1000 uses. If it is used 1000
working cycles, the machine will emit a reminder signal when turned on and the indicator lights
will blink in red twice.
1.
Fill the water tank with water and descaling product up to the MAX. level. Citrus can also
be used.
Note: Water and descaling proportion is 4:1.
2.
Press the On/off button, the machine will start preheating and the indicator light will turn
on steady.
22
POWER ESPRESSO 20 BARISTA PRO
3.
Insert the portafilter in its position and make sure it is securely fitted.
4.
Place a large container (approx. 2 L) on the cup-holder tray. Make sure it is big enough so
that water coming out from the water tube, nozzle and steam tube can fall inside it.
5.
Press and hold the Hot water button for 5 seconds for the machine to enter Autocleaning
mode.
6.
Turn the steam knob to the MAX. position. Hot water with descaling product (or the used
one) will be emitted through the portafilter spouts and hot water and steam tubes. This
process will take from 10 to 15 minutes, then the coffee machine will turn off.
7.
Once it has finished, fill the water tank with clear water and repeat these steps until there
is no more descaling product.
8.
Clean the water tank and the drip tray.
Notes:
– During the Autocleaning process, the pump will turn on and off intermittently, this is normal
and does not involve malfunction.
– During the Autocleaning process, the steam knob must not be set at "0". The machine will
beep once to remind it must be turned to the MAX. mark in order to clean the steam tube.
6. TROUBLESHOOTING
PROBLEM
Water leaks from the bottom
There is too much water in
of coffee maker.
the drip tray
The coffee maker is damaged
Water leaks from the
There is some coffee powder
portafilter holder
on filter edge
Water leaks from the
There is some coffee powder
portafilter holder
on filter edge
ENGLISH
CAUSE
SOLUTION
Empty and clean the drip tray
Contact the official Technical
Support Service of Cecotec
Clean the filter and
portafilter holder
Clean the filter and
portafilter holder
POWER ESPRESSO 20 BARISTA PRO
23
Publicidad
