Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
2.
Set the steam control knob to
3.
Fill the water tank up to the "MAX" level mark and close the lid.
4.
Plug in the iron and turn the temperature control knob to "MAX".
5.
When the heating indicator turns off, unplug the iron from the mains socket.
6.
Hold the iron horizontally over a kitchen sink or a large heat-resistant container.
7.
Keep the steam control knob pressed to the left in the "Self-Clean" position to start the
self-cleaning process. Hot water and steam will start to leak out of the soleplate, along
with any impurities. Gently move the horizontal iron backwards and forwards during the
process.
WARNING!
The steam and water escaping from the iron are extremely
hot. Always keep your face and hands a safe distance
from the iron.
8.
When the process is complete, release the steam control knob.
9.
Empty any water remaining in the water tank.
Troubleshooting
Use this troubleshooting guide to resolve any common problems that you may encounter with
the unit. If the problem persists, do not use the unit and contact an authorised repair centre
to have it inspected or repaired.
Problem
The iron is not
heating up.
No continuous
steam is being
produced or the
continuously
released steam is
too weak.
.
Possible Cause
• The iron is not connected
to the mains socket.
• The temperature control
knob is set to "MIN".
• The tank is empty or
the water level is too
low.
• The iron was used
when the heating
indicator was lit.
• Incorrect temperature
and steam settings.
25
Solution
• Connect the iron to a suitable mains
socket.
• Turn the temperature control knob
to the required setting.
• Fill the water tank up to the "MAX"
level mark.
• Before using the iron, wait for the
heating indicator to turn off.
• Make sure the iron has been set
correctly (
Continuous steam).
EN
Publicidad
