Worx WG284E Manual Original página 12

Installing and Removing the battery
pack
NOTE :
• This machine will only run
when 2 batteries are installed.
It is recommended to use the
same two batteries and charge
the two batteries at the same
time.
• When you use two batteries
with different power, the
machine will only run to the
lower common denominator.
OPERATION
Remove the blade sheath
Starting and stopping
Rotating rear handle
NOTE :
• Unlock the locking switch before
rotating.
• After rotating the handle to the
desired position, adjust it a little
until a click can be heard.
WARNING:
12
• Always make sure that the
handle is locked in the desired
position before operation.
• Always make sure the locking
switch is locked before starting
the hedge trimmer.
Top cutting
WARNING: If any parts are
missing, damaged or broken,
do not operate your hedge trimmer
until all damaged parts have been
replaced or repaired. Failure to do so
could result in serious personal injury.
DO NOT USE WITHOUT FRONT HANDLE
AND SAFETY GUARD.
Side cutting
WARNING: Stop operating the trimmer
before rotating the handle.
Lubricating the Cutting Blade
NOTE : It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
To store your hedge trimmer
Hedge trimmer
5. HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
See Fig. E
with both hands and with the blade away from you
before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
See Fig. F
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
See Fig.
Wear gloves when trimming thorny or prickly growth.
G1, G2
Do not attempt to cut stems that are too thick for the
cutting blade.
Top cutting
Use a wide sweeping motion (See Fig. E1). A slight
downward tilt of the cutting blades in the direction of
motion gives the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at the
See Fig.
bottom and cut upwards, tapering the hedge inward
H1, H2
at the top. This shape will expose more of the hedge,
resulting in a more uniformed growth
6. MAINTENANCE
Remove the battery from Hedge trimmer before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
See Fig. I
Keep all working controls free of dust.
7. ENVIRONMENTAL
PROTECTION
See Fig.
Waste electrical products should not be
J1, J2
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
See Fig. K
See Fig. L
EN