Gastrodomus WME40DDP Manual Del Usuario página 25

DISPENSER ADJUSTMENT DURING THE CYCLES
The adjustment of dispensers during the cycles and tank filling can be carried out with the machine on, door open or
during a washing cycle. To modify the dispenser parameters, access the main parameter menu, following and paying
attention to the sequence of the instructions listed below.
Press the buttons shown below at the same time for 6 seconds,
one of the general parameters from the list will appear on the
display
press the parameter scrolling buttons, "III" back button, forward
button "By pass" until the desired parameter is shown on the
display
press the "II" button to increase (+) press the "I" button to
decrease (-) the assigned default value
once the parameter is modified, press the " Drain" to confirm,
as shown below in the figure
to exit the parameter menu, press the buttons shown below
in the figure at the same time for 6 seconds
Suggestion: to check the effectiveness of the rinse aid, look at glasses that were just washed up against the light. Drops
of water on the glass indicate that the amount is not sufficient, streaks indicate an excessive amount.
Replacing the type of detergent and rinse aid: If the type of detergent/rinse aid is being changed, even if it is the same
brand, the intake and delivery pipes must be rinsed with clean water before connecting the new detergent/rinse aid
container. Otherwise, the mixture between different types of detergent/rinse aid could cause crystallisation, possibly
causing the dispensing pump to break. Failure to observe this precaution annuls the warranty and manufacturer liability.
31. MAINTENANCE
• Once or twice a year, descale the boiler, the inner surfaces of the basin and the machine pipes.
Each month, descale the rinsing and washing jets in a bath of vinegar or descaling agent.
•
The tube inside the peristaltic rinse aid and detergent dispenser must be subjected to periodical maintenance (once
•
or twice a year).
Prolonged period of inactivity
If dishwashers remain unused for a long period of time, proceed as follows:
Close the supply water cock.
•
Completely empty the basin
•
• Remove and clean the filter carefully
• Completely empty the built-in dispenser tubes, removing the tubes from the cans
Completely empty the boiler by pressing the 2 keys shown below in the figure at the same time for a few seconds
•
until "Boiler Emptying" appears on the display, which starts the draining phase for the automatic emptying of the
boiler and the basin.
pag. 24 DOC. W010215 – REV.2