Gastrodomus WME40DDP Manual Del Usuario página 29

37. TROUBLESHOOTING
THE DISHWASHER DOES NOT
WASH WELL
THE GLASSWARE AND DISHES ARE
NOT DRY
CONDENSATE ON THE
GLASSWARE
SPOTS ON THE GLASSWARE
EXCESSIVE PRESENCE OF FOAM IN
THE BASIN
GLASSWARE STREAKED OR
SPOTTED
THE WASHING AND/OR RINSING
ARMS TURN SLOWLY
pag. 28
Check if the intake filter is dirty and clean it thoroughly.
Check that the washing jets are not obstructed by solid residue
Check that the quantity of the initial detergent and/or the additions during the
The selected washing cycle is too short. Repeat the cycle.
Check that the basin temperature is between 50°C and 65°C.
Check that the dishes are positioned correctly in the baskets.
Check the instructions for the amount of rinse aid (see paragraph "dispenser
adjustment"). Check that there is rinse aid in the container and fill it up if
Check the quantity of rinse aid used (see paragraph "dispenser adjustment").
Check that the temperature of the rinsing water is between 80°C and 90°C.
Check that there is rinse aid in the container and fill it up if necessary.
Check the quantity of rinse aid used (see paragraph "dispenser adjustment").
Remove the basket with the glassware immediately after the cycle has ended
Use only "non foaming" products for professional dishwashers
Check that the washing water temperature is not lower than 50°C.
Check if the detergent dispenser releases too much product (see paragraph
Make sure that the basin was cleaned with suitable detergents.
If a foaming detergent was used, refill the basin with water until the foam has
Reduce the amount of rinse aid (see paragraph "dispenser adjustment").
Remove the arms and clean them thoroughly (see paragraph "3.4 end of service
Clean the washing pump intake filter.
washing cycle are correct.
necessary.
"dispenser adjustment").
disappeared.
and daily cleaning").
DOC. W010215 – REV.2