MIRKA 1230 M Instrucciones De Manejo página 88

en
4.2 Transport
• Before transporting the machine, close all the container clamps .
• Close the inlet with the inlet cap .
• Do not tilt the machine if there are liquids in the container .
• Do not use a crane hook to lift the machine .
• Do not lift the machine by the trolley handle
4.3 Storage
CAUTION
Store the appliance in a dry place, protected from rain and frost . The machine must be stored indoors only .
4.4 Accessory and tool storage
For convenient transport and storage of accessories or tools, integrated rails are provided on the side of the machine,
which allow fastening with straps or some other means . A flexible strap and hooks are included at the back of the
machine for hanging the suction hose or mains cable . For instructions, see quick reference guide .
An optional case fastening accessory with attachment system can be installed on top of the machine for fastening of
2-point or 4-point storage cases . Unplug from the socket before installing the case fastening accessory .
CAUTION
Do not lift machine and case fastening accessory without ensuring that the storage case is safely installed . Note the
weight and balance of the appliance in case of storage . Maximum weight of storage cases is 30 kg .
4.5 Recycling the machine
Make the old machine unusable .
1 . Unplug the machine .
2 . Cut the power cord .
3 . Do not discard electrical appliances with regular household waste .
As specified in European Directive 2012/19/EU on old electrical and electronic appliances, used electrical
goods must be collected separately and recycled ecologically .
5. Maintenance
5.1 Regular servicing and inspection
Regular servicing and inspection of your machine must be carried out by suitably qualified personnel in accordance
with relevant legislation and regulations . In particular, electrical tests for earth continuity, insulation resistance, and
condition of the flexible cord should be carried out frequently .
In the event of any defect, the machine MUST be withdrawn from service, completely checked and repaired by an
authorized service technician . At least once a year, a Mirka technician or an instructed person must perform a technical
inspection including filters, air tightness and control mechanisms .
5.2 Maintenance
Remove the plug from the socket before performing maintenance . Before using the machine make sure that the
frequency and voltage shown on the rating plate correspond with the mains voltage .
88
Mirka® Dust Extractor • 1230M & 1242 M • 230 V / 100–120 V • PC & AFC