Publicidad
Idiomas disponibles
Idiomas disponibles
The Hayward Light Controller offers a dedicated solution for controlling your ColorLogic LED lights
from a single convenient remote location. It's designed to install into a standard wall electrical box
and is wired to the high voltage side of the ColorLogic light's transformer. Once installed, the Light
Controller can be used to fully control your lights. Turn lights on/off, change colors, set a schedule
and countdown timer using the rotary knob and front buttons.
UCL Mode - UCL mode is used for ColorLogic lights built before June 2018 and do not support
OmniDirect mode. UCL mode will display 10 fixed colors and 7 shows.
OmniDirect Lite Mode - Enables instant selection of colors/shows, speed and dimming. OmniDirect
Lite mode is used for ColorLogic lights built after June 2018. Although these lights are capable of
displaying 20 fixed colors and 7 shows when controlled by Hayward Omni automation controllers in
OmniDirect mode, the Hayward Light Controller only supports OmniDirect Lite mode which are the
same 10 fixed colors and 7 shows as UCL mode.
Specifications
CSA enclosure type: Type 2, ENCL 2, or equivalent
Indoor electrical box: UL recognized single or multi gang with minimum 14.0 in
Outdoor electrical box: UL recognized single or multi gang with minimum 18.0 in
Compatibility
The Light Controller is compatible with the following ColorLogic Low Voltage LED lights:
•
Universal ColorLogic Pool LED Light
•
Universal ColorLogic Spa LED Light
•
ColorLogic 320, 160 and 80 LED Lights
IMPORTANT: Total allowable light wattage for the Light Controller is 300 watts. A combination of
various lights can be used but total wattage must not exceed 300 watts. Refer to your ColorLogic
light's power consumption when determining how many lights to use with the Light Controller. An
example of combinations are shown below:
•
3 Pool Lights
•
2 Pool Lights and 1 Spa and/or Accent Light
•
1 Pool Light and 4 Spa and/or Accent Lights
•
6 Spa Lights
•
6 Accent Lights (320 model)
•
Any combination that does not exceed 300 watts
IMPORTANT: Add the individual wattage for each light and do not exceed 300 watts.
Before you Begin
The Light Controller requires a Neutral connection to operate. If retrofitting into an existing installation,
make sure that the electrical box contains a Neutral connection.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Introduction
volume
3
volume
3
2
Publicidad
