Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting Location
The Light Controller is a single pole switch and installs into a standard electrical outlet box. When
determining a suitable location, consider that wiring from the Light Controller must connect to the
primary side of the light's low voltage transformer.
Note that the Light Controller is designed for indoor use but can be mounted outdoors if a suitable
UL rated weatherproof outlet box and cover are used.
Wiring
Lever action terminal blocks are included to aid in installation. Move levers to
the fully open position when inserting wires. Close the levers to lock the wires
in place.
Connect the Light Controller's green wire to ground using one of the supplied lever
action terminal blocks. The Light Controller comes with a plug-in wiring harness
for easy installation and removal. All wiring connections should be made directly
to the harness using the additional lever action terminal blocks. After wiring is
complete, the harness can be plugged into the back of the Light Controller. It
can then be secured into the electrical box. Refer to the following diagram for wiring connections.
3
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Installation
Wiring
To Transformer
White
Red
Black
Green
Close Lever
(Lock Wire)
Wiring
From
Supply
Open Lever
(Insert Wire)
Publicidad
