Descargar Imprimir esta página

Hayward ColorLogic LKCUS1100 Manual De Instrucciones página 5

Ocultar thumbs Ver también para ColorLogic LKCUS1100:

Publicidad

Idiomas disponibles

Idiomas disponibles

After wiring is complete, turn on power at the circuit breaker that is connected to Light Controller.
The Light Controller will initiate communication with the ColorLogic lights. This may take a minute or
two as the lights will cycle between colors and finally default to the Voodoo Lounge light show. The
Light Controller will indicate this in the PREVIEW WINDOW.
Refer to the following information for operation and control of your ColorLogic lights.
Onboard Pushbuttons
For best results, press on the outside of pushbuttons.
SHOW/COLOR - this is the default mode and is used to control light shows and colors.
SCHEDULE - this is a programming mode and is used to set a countdown timer or schedule.
RESYNC/SPEED - this button is used to adjust the speed of light shows (OmniDirect Lite
mode) or to resume connection with lights if communication is interrupted (UCL mode).
ENTER/BRIGHTNESS - use this button to change the brightness of colors and shows
(OmniDirect Lite mode) as well as to confirm a selection while in SCHEDULE mode.
CENTER KNOB - To turn the lights on, briefly push on the CENTER KNOB. To turn the lights
off, push in and hold for 3 seconds. To change a show or color, rotate the CENTER KNOB to
the desired show/color and push the CENTER KNOB briefly to save.
PREVIEW WINDOW - this is the LCD display above the CENTER KNOB. The PREVIEW
WINDOW shows the color or light show that has been selected via the CENTER KNOB. The
PREVIEW WINDOW will remain on 5 minutes after the last user input.
Off & On
Turn the lights on by briefly pushing in the CENTER KNOB. To turn off, push on the CENTER KNOB and
hold for 3 seconds. The Light Controller may indicate that it's "busy" by cycling through all LEDs in a
circular pattern. This is normal operation and occurs whenever the Light Controller is busy processing
a request. Let the Light Controller come out of this state before continuing.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Operation
1
To Turn ON,
briefly push the
CENTER KNOB
2
To turn OFF, hold
the CENTER
KNOB for 3
seconds
4

Publicidad

loading

Este manual también es adecuado para:

Colorlogic lkcub1100