Waterpik Water Flosser WF-10 Manual De Instrucciones página 10

10
BATTERY REMOVAL
1
Remove
2
3
Remove
4
Break
Cut
Joint
Remove
Battery
The product contains battery and/or recyclable electronic waste. In order to protect the environment, please do not dispose along with
household waste. When battery life ends, please dispose or recycle according to local administrative regulations. Please contact local
waste administrative department for any question.
If you intend to dispose the battery on your own, for example, for WF-10 model, please follow below steps to remove the battery:
1. Power of the device, remove reservoir.
2. Wrap in a towel and hit with a hammer to break the joint between the front, rear, and lower housings.
3. Remove 2 screws holding pump assembly to rear cover and 4 screws holding battery housing to pump assembly.
4. Carefully break the joint between the battery housing and rear cover.
Cut battery wires (careful not to short positive and negative wires together) and
remove battery.
The removed battery should be disposed safely by special recycling center.
Warning: The battery of this product is not replaceable. Please do not disassemble the product unless you want to dispose it.
Otherwise the warranty service will be void.