Publicidad
Idiomas disponibles
Idiomas disponibles
Connection with the remote control
1. Switch on the device and press and hold the „
the „
"-button for the linear speed at the same time for approx. 5 seconds. Release the buttons
after a beep was emitted and now immediately press the „
linear speed).
2. Now press any button on the remote control. The remote control should now be connected to the
vibration plate. If no reaction on the display of the device can be seen, repeat step 1 and check again,
if a connection has now been established.
3. Now press the MODE-button to save the setting.
4. Switch off the device and switch it on again; the remote control should now be functionable.
Remote control operation
Before workout: Time selection.
1.
During workout: Linear speed increase.
Before workout: Mode selection.
2.
During workout: Linear speed decrease.
3.
Oscillation speed increase.
4.
Oscillation speed decrease.
5.
Start/ Stopp-button.
The effective transmitting range of the remote control is 2.5 meters.
Align the infrared emitter of the controller to the receiving window on the display of the unit for best
results.
Replacing the battery
12
" - adjusting button for the oscillation speed and
"-button (button for increasing the
Publicidad
