Publicidad
Idiomas disponibles
Idiomas disponibles
Drain Valve:The drain valve is located
at the base of the air tank and is used
to drain condensation
at the end of
each use.
Motor Overload
Protector:
This
motor has a manual thermal overload
protector. If the motor overheats for
any reason, the overload protector
will shut off the motor. The motor
must be allowed to cool down before
restarting.
To restart:
1.
Place the On/Auto/Off lever in the
"Off" position.
2.
Allow the motor to cool.
Check Valve: When the air compres-
sor is operating, the check valve is
"open", allowing compressed air to
enter the air tank. When the air com-
pressor reaches "cut-out" pressure,
the check valve "closes", allowing air
pressure to remain inside the air tank.
Pressure Release Valve: The pres-
sure release valve located on the side
of the pressure switch, is designed to
automatically release compressed air
from the compressor head and the
outlet tube when the air compressor
reaches "cut-out"
pressure or is shut
off. The pressure release valve allows
the motor to restart freely. When the
motor stops running, air will be heard
escaping from this valve for a few sec-
onds.
No air should be heard leaking
when the motor is running or after the
unit reaches "cut-out" pressure.
3.
Depress the red reset button on
the motor.
4.
Place the On/Auto/Off lever in the
"On/Auto" postion to restart the
motor.
Air intake Filter (not shown): This
filter is designed to clean air com-
ing into the pump. This filter must
always be clean and ventilation
openings free from obstructions.
See
"Maintenance".
HOW TO USE YOUR
UNiT
How to Stop:
1.
Set the On/Auto/Off
lever to "Off".
Before Starting
Do not operate this
unit until you read
and understand
this instruction
manual for safety, operation
and
maintenance
instructions.
Break-in Procedure
Risk of Property
Damage. Serious
damage may result if the following
break-in instructions are not
closely followed.
This procedure is required before the
air compressor
is put into service and
when the check valve or a complete
compressor
pump has been replaced.
N001248
14-ENG
Publicidad
