Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Make sure the On/Auto/Off
lever is
in the "Off" position.
2.
Check oil level in pump. See "Oil"
paragraph in the Maintenance
section for instructions.
3.
Recheck all wiring. Make sure
wires are secure at all terminals
connections. Make sure all con-
tacts move freely and are not
obstructed.
4.
Open the globe valve fully to per-
mit air to escape and prevent air
pressure build up in the air tank
during the break-in period.
5.
Move the On/Auto/Off lever to
"On/Auto" position. The compres-
sor will start.
6.
Run the compressor for 20 min-
utes. Make sure the globe valve
is open and there is minimal air
pressure build-up in tank.
7.
Check all air line fittings and con-
nections/piping
for air leaks by
applying a soap solution. Correct
if necessary. NOTE: Minor leaks
can cause the air compressor to
overwork, resulting in premature
breakdown or inadequate perfor-
mance.
8.
Check for excessive vibration.
Readjust or shim air compressor
feet, if necessary.
9.
After 20 minutes, close the globe
valve. The air receiver will fill to
"cut-out"
pressure and the motor
will stop.
Before
Each Start=Up:
1.
Place On/Auto/Off
lever to "Off".
2.
Close the globe valve.
3.
Attach hose and accessories.
_Risk
of unsafe
--
operation.
Firmly
grasp air hose in hand when
installing or disconnecting
to
prevent hose whip.
Risk of unsafe
operation.
Do not
use damaged
or worn accessories.
NOTE: A regulator MUST be installed
when using accessories rated at less
than 175 Psi.
NOTE: The hose or accessory will
require a quick connect plug if the air
outlet is equipped with a quick con-
nect socket.
Risk of Bursting.
Too much air
pressure causes a hazardous
risk of
bursting.
Check the manufacturer's
maximum
pressure
rating for air
tools and accessories.
The regulator
outlet pressure must never exceed
the maximum pressure rating.
_Risk
of unsafe
--
operation.
Compressed
air from the unit may
contain water condensation
and
oil mist. Do not spray unfiltered
air
at an item that could be damaged
by moisture.
Some air tools and
accessories
may require filtered
air. Read the instructions for the air
tools and accessories.
How to Start:
1.
Turn the On/Auto/Off
lever to "On/
Auto" and allow tank pressure to
build.
Motor will stop when tank
pressure reaches "cut-out"
pres-
sure.
2.
When the tank pressure reaches
"cut-out" pressure open the globe
valve.
IMPORTANT: When using regula-
tor and other accessories refer to the
manufacturers
instructions.
_lf
any unusual
__
noise or vibration
is noticed, stop the compressor
immediately and have it checked
by
a trained service technician.
The compressor
is ready for use.
15-ENG
N001248
Publicidad
