DeWalt D55154 Manual De Instrucciones página 23

CODE POSSIBLE CAUSE POSSIBLE SOLUTION
10 Hole in air hose Replace air hose.
11 ' Check valVe restricted Remove; clean or replace:
12 Air leaks Tighten fittings.
13
14 Unit operating in damp or humid conditions Move unit to a dry well ventilated area
15 .........
16 Engine or pump oil is low Add same type of oil in crankcase to pump. See
Compressor Pump Oil under Maintenance.
Contact a DEWALT factory service center or a DEWALT
• authorized service center.
18 Detergent type oil being used in pump Drain oil and refill pump using DeWALT synthetic or SAE
40, non=detergent air compressor oil.
19 Motor overload protection switch has tripped' See IVlotor Overload under Features.
20 Extension cord is wrong length or gauge Check for proper gauge wire and cord length. See
Extension Cords under Instaflation.
2i Eoose e ectr ca connect 0ns contact a DEWALT factory service center or a DEWALT
authorized service center.
22 Possible defective motor or starting capacitor Contact a DEWALT factory service center or a DEWALT
authorized service center.
23 Pa nt spray on nterna motor parts contact a DEWALT factory service center DEWALT
authorizedservicecenter. Do not operate the compressor
I
I in the paint spray area, See flammable vapor warning,
23