Break-In Procedure - DeWalt D55154 Manual De Instrucciones

Compresor de aire elctrico sobre ruedas, tipo remolque de 17,6 litros (4galones)
Ocultar thumbs Ver también para D55154:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DOLLY FEATURE
1. Grasp handle (O) of compressor
and pull up
until it stops. Turn knobs to lock handle in
place. IMPORTANT: Always pull handle up
and lock in place before using as a dolly.
2. Place cargo onto top panel of compressor.
3. Secure cargo to top panel with retention
straps.
Hook cargo retention
straps into
positioning
holes
in top
panel.
NOTE:
Retention
straps to secure cargo may be purchase from a
local hardware store or home center in a variety of sizes.
CAUTION:
Risk
of
unsafe
operation.
Do
not
transport
unsecured cargo.
CAUTION:
Risk
of unsafe
operation.
Load
limit is 100 Ibs.
do not exceed.
4. With cargo secured, grasp handle and tilt
compressor
so unit can be rolled on the
tires.
,_ WARNING: Risk of unsafe operation. Ensure
proper footing
and use caution when rolling
compressor so that unit does not tip or cause
loss of balance.
5. When
location
is reached
slowly
lower
compressor
to ground. Always store com-
pressor in a horizontal position.
PFtEPARATION
FOR
USE
Pre-Start
Checklist
(Fig.
1)
1. Ensure the On/Off switch (A) is in the OFF position.
2. Plug the power cord into the correct branch circuit receptacle.
See Voltage and Circuit Protection
under Installation.
3. Ensure air tank is drained,
see Draining
Air Tank under
Maintenance.
4. Ensure the drain valve (H) is closed.
5. Ensure safety valve (G) is functioning
properly, see Checking
Safety Valve under Maintenance.
6. Check pump
oil level, see Compressor
Pump
Oil under
Maintenance.
CAUTION: Do not operate without oil or with inadequate oil. DEWALT
is not responsible for compressor failure caused by inadequate oil.
7. Turn regulator
knob (D) counterclockwise
until fully closed.
Ensure regulated pressure gauge reads 0 PSI (0 kPa).
8. Attach hose and accessories.
WARNING: Risk of unsafe operation. Firmly grasp hose in hand
when installing or disconnecting
to prevent hose whip.
9. Ensure all covers and labels are in place, legible (for labels) and
securely mounted. Do not use compressor
until all items have
been verified.
_k WARNING: Risk of bursting. Too much air pressure
causes a
hazardous
risk of bursting. Check the manufacturer's
maximum
pressure rating for air tools and accessories.
The regulator outlet
pressure must never exceed the maximum pressure rating.
Initial
Set.up
(Fig.
t)
_& WARNING: Do not operate this unit until you read and understand
this instruction
manual
for safety, operation
and maintenance
instructions.
BREAK-IN PROCEDURE
CAUTION: Risk of property damage. Serious damage may result ff
the following break-in instructions are not closely followed.
This procedure
is required
before
the air compressor
is put
into service for the first time and when the check valve or a
compressor
pump/motor
has been replaced.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido