Publicidad
Idiomas disponibles
Idiomas disponibles
If an error occurs, the 'ice full' and 'add water' indicators will flash simultaneously – the ice
maker will stop working. Please refer to the 'troubleshooting' page.
When not in use, turn off and unplug the machine.
Ice storage capacity
* When the ice basket is full, the machine will stop automatically and enter standby.
* The ice maker can partially block heat and store ice temporarily, but cannot be used as
a freezer.
* Please remove ice cubes and add water to ensure the machine works properly.
Sounds during machine operation
Your new ice maker may make unfamiliar sounds. Most sounds are normal, for example:
* Efficient compressors emit beating or sharp sounds.
* Water splashes from the evaporator to the tank.
* At the end of each cycle, you can hear the gurgling of the refrigerant flowing.
* The sound of air compressed by the fan over the condenser.
* In the final cycle, you may hear ice falling into the box.
Cleaning and maintenance
Regular cleaning and correct maintenance will keep your machine in top working
condition.
* Before cleaning, turn off and unplug the machine.
* Do not use solvent-based cleaning agents, which may damage the machine.
* Do not wash the machine. Wipe the outside of the machine with a damp cloth.
* Regularly check the drain plug, ensuring it is tight to prevent leakages.
After the first use or if it has not been used for long periods, clean the machine.:
* Disinfection solution: water and vinegar or citric acid (ratio: 10:1).
* Wipe the inside with a solution, including the evaporator (icing column).
* Add ice making water, run the machine and discard the ice cubes produced – repeat this
four times, then remove the remaining water from the drain and reinstall the plug.
* Use a clean, soft cloth to remove any remaining watermarks.
Strange smells
If the ice has a strange taste or odour, follow the above steps to clean the inside of the
machine.
Storage
If the ice maker is not in use for long periods, turn off and unplug the machine, ensuring
all water has been drained. Dry the interior with a soft, clean cloth (refer to maintenance
and cleaning).
Warning:
Don't touch the power supply with wet
hands!
Don't pull out the machine by pulling
the power cord
Publicidad
