Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
Using the tool
Note: Sparks may be visible through the slots in the motor housing during operation.
The sparks are a normal reaction of the motor when in use and are created by the
components inside the motor moving against each other. The function of the power tool
is not affected by this. We do however recommend not to use the power tool near any
flammable liquids, gases or dust, which the sparks may ignite.
Keyless chuck
Your drill has a keyless chuck so that you can simply tighten or release screwdriver/drill
bits. Hold the front sleeve and push on the speed control/trigger to open/close the chuck.
Mounting bits and drills
Before any work on the machine (e.g. maintenance, tool change, etc.) as well as during
transport and storage, set rotational direction switch to the centre position. Unintentional
actuation of the trigger can lead to injuries.
Rotate the front sleeve to adjust the chuck until the opening is slightly larger than the
shaft of the screwdriver/drill bit that you wish to use. Insert the screwdriver/drill bit into
the chuck. Tighten the chuck against the screwdriver/drill as described above (Keyless
chuck).
Regulating the shaft speed
It is possible to regulate both shaft speeds from zero to maximum by altering the
pressure applied to the trigger. This enables you to choose the optimum speed for the
task you are working on.
Reversing the direction of rotation
You can reverse the direction of rotation by using the rotational direction switch (4).
To lock the trigger, set the selector to the mid position between the right and left options.
Adjusting the tightening moment
Turn the torque regulator (2). to the desired position. Settings 1-19 are used for
tightening/loosening screws (the higher the value, the greater the tightening moment).
Select the drill symbol before using the tool for drilling.
Magnetic bit holder
You can place the bits and drills you are currently using on the magnetic bit holder (8) on
top of your screwdriver/drill to keep them close at hand while you are working.
12
Publicidad
